1 Scope
This standard specifies the types, main technical parameters, technical requirements, test methods, inspection rules and the requirements of marking, packaging, transportation and storage of batch warping machine.
This standard is applicable to batch warping machines for the warping of cotton, chemical fiber and blended 97.2 tex~5.83 tex (6s~100s) yarn.
2 Normative References
The following documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding any corrigendum), or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For any undated references, the latest edition of the document referred to applies.
GB/T 191-2000 Packaging - Pictorial Marking for Handling of Goods
GB/T 1032-1985 Test Procedure for Three-phase Induction Motors
GB/T 7111.1-200 Textile Machinery - Noise Test Code - Part 1: Common Requirements
GB/T 7111.5-2002 Textile Machinery - Noise Test Code - Part 5: Weaving and Knitting Preparatory Machinery
GB/T 9239-1988 Balance Quality of Rigid Rotors - Determination of Permissible Residual Unbalance
FZ 90001-1991 Product Package of Textile Machinery
FZ/T 90035-1992 Textile Machinery - Warper Beam Terms and Main Dimension
FZ/T 90074-1995 Painting for the Products of Textile Machinery
FZ/T 90083-1995 Textile Machinery - Wrap Creel - Main Dimensions
FZ/T 90089.1-1996 Type, Size of and Technical Requirements for Textile Machinery Nameplate
FZ/T 90089.2-1996 Content of Textile Machinery Nameplate
FZ/T 99014-1995 Electrical Equipment of Textile Machinery - Technical Requirements
3 Product Types and Main Technical Parameters
3.1 Types
3.1.1 Transmission type: direct transmission warper beam.
3.1.2 Pressurization type: direct pressurization or indirect pressurization.
3.1.3 Bobbin creel type: V-shaped, rectangle, V- rectangle frame.
3.2 Main technical parameters
3.2.1 Warping linear speed: 0~1 000m/min.
3.2.2 Maximum nominal breadth: 2 000mm.
3.2.3 Side disk diameter of warper beam: 800mm, 1 000mm.
3.2.4 Length of pressurizing roller: (nominal breadth -4)+0 -0.5 mm.
3.2.5 Main dimensions of warper beam shall meet the requirements of FZ/T 90035-1992.
3.2.6 Main dimensions of bobbin creel shall meet the requirements of FZ/T 90083-1995.
Foreword i
1 Scope
2 Normative References
3 Product Types and Main Technical Parameters
4 Technical Requirements
5 Test Methods
6 Inspection Rules
7 Marking, Packaging, Transportation and Storage
