標準編號:	TB/T 1613-1985
中文名稱:	貨車手制動裝置設計參數
英文名稱:	Design Parameter of Truck Hand Braking Device Design
行業分類:	TB    鐵路運輸行業標準
發布日期:	1985-12-14
實施日期:	1987-1-1
標準狀態:	valid
翻譯語言:	英文
文件格式:	PDF
中文字符數:	1000 字
翻譯價格(元):	300.0
交付時間:	付款后 1 個工作日

Codeofchina.com is in charge of this English translation. In case of any doubt about the English translation, the Chinese original shall be considered authoritative. Design Parameter of Truck Hand Braking Device Design This standard is applicable to design parameters of chained hand brake configured on newly-designed truck (open, covered, flat, tank and guard one) with standard gauge in railway. 1. The horizontal distance from hand braking axle center to longitudinal centerline of truck body is 490~500mm. 2. The distance between hand braking pedal to top edge of hand braking wheel is 950~1050mm. 3. The position of pull rod guide frame shall ensure that the dimension E of hand braking pull rod shall not be less than 50mm under the maximum stroke. 4. To prevent the split pin at the lower end of hand braking axle from being extracted after shedding, h2 < h1. 5. Position of hand braking wheel on truck: 5.1. The minimum distance from the lower edge of hand braking wheel of covered truck to top surface of covered truck shall not be less than 80mm. 5.2. The distance from the lower edge of hand braking wheel of tank truck and guard truck to top edge of handrail of truck end shall not be less than 80mm. 5.3. Where the hand braking wheel of open truck is above the upper end beam, the minimum distance from lower edge of wheel to upper end beam shall not be less than 80mm; where the hand braking wheel of open truck is below the upper end beam, the minimum distance from upper edge of wheel to upper end beam shall not be less than 200mm. 6. Hand braking axle chain must be provided with reeling amount of 0.5~2 circles.

中華人民共和國鐵道行業標準 TB/T 1613－85 貨車手制動裝置設計參數 1985—12—14發布 1987—01—01實施 中華人民共和國鐵道部 發布 貨車手制動裝置設計參數 本標準適用于鐵路標準軌距新設計貨車(敞、棚、平、罐、守車)裝用鏈式手制動機的手制動裝置設計參數。 1. 手制動軸中心到車體縱向中心線的水平距離為490～500mm。 2. 手制動踏板到手制動手輪上邊緣的距離為950～1050mm。 3. 拉桿導架的位置，應保證手制動拉桿在最大行程下，尺寸E不得小于50mm。 4. 為防止手制動軸下端的開口銷脫落后手制動軸被拔出，規定h2